-17%
KS103 高精度超聲波測距模組 支援 I2C 和 TTL串口通訊 1cm-8M 高精度1mm
KS103 高精度超聲波測距模組 支援 I2C 和 TTL串口通訊 1cm-8M 高精度1mm

KS103 高精度超聲波測距模組 支援 I2C 和 TTL串口通訊 1cm-8M 高精度1mm

0 out of 5
( 目前沒有評價。 )

原始價格：NT$1,100。目前價格：NT$910。 (未稅)

狀態: 尚有庫存 貨號: SNG-003378 分類: 標籤: , , , ,

描述

KS103 高精度超聲波測距模組 支援 I2C 和 TTL串口通訊 1cm-8M 高精度1mm

功能強大，性能穩定，性價比遠遠超過SRF08/SRF10的超聲波測距模塊，超聲波傳感器 KS103。包含實時溫度補償的距離探測，高探測精度（精度範圍1mm~3mm），採用專利技術的探測模式，探測範圍1cm ～80 0cm。使用 I2C 接口與主機通信，自動響應主機的 I2C 控制指令。共 20 個可修改的 I2C 地址，範圍為 0xd0 ~ 0xfe (0xf0,0xf2,0xf4,0xf6 除外 )。83ms 快速、高精度的溫度探測，隨時感知環境精確溫度。5s 未收到 I2C 控制指令自動進入 uA 級休眠，並可隨時被主機 I2C 控制指令喚醒。短距探測量程由 10cm 、 20cm 、……、至 470cm ，滿足快速近距探測。1ms 快速光強探測，即時探測實時光強。工作溫度( -30 ℃ ~+85 ℃ )。寬工作電壓 (3.0V~5.5V)

  • 工作電壓：3.0V~5.5V直流電源
  • 工作時瞬間最大電流：10.6mA@5.0V , typical
  • 工作電流：1.6-2.7 mA@5.0V , typical
  • 休眠時最大耗電量：500uA@5.0V , typical
  • 功耗：使用納瓦技術省電，5s 未收到I 2 C 控制指令自動進入uA 級休眠，並可隨時被主機I 2 C控制指令喚醒。
  • 可以可靠地同時接20個KS103 ,在其中一個模塊進行探測工作時其他模塊自動進入低功耗休眠，經測試，即使僅使用約3.0V電壓(約兩節乾電池電壓)對20個KS103進行供電。

●包含實時溫度補償的距離探測，高探測精度，最高精度可達1mm
●採用專利技術的探測模式，探測範圍1cm～800cm及1cm~1000cm（10米）
●探測頻率可達500Hz，即每秒可探測500次
●使用I2C/串口接口與主機通信，自動響應主機的I2C/串口控制指令
●共20個可修改的I2C/串口地址，範圍為0xd0 ~ 0xfe (0xf0,0xf2,0xf4,0xf6除外，8位地址)

●  83ms快速、高精度的溫度探測，隨時感知環境精確溫度
● 5s未收到I2C控制指令自動進入uA級休眠，並可隨時被主機I2C控制指令喚醒
●  短距探測量程由10cm、20cm、…… 、至470cm，滿足快速近距探測
● 1ms快速光強探測，即時探測實時光強
●工作溫度-30℃-85℃
●寬工作電壓範圍(3.0V~5.5V)
●採用獨特的可調濾波降噪技術，電源電壓受干擾或噪音較大時，仍可正常工作

High precision Ultrasonic sensor ks103 1cm-8M Ultrasonic distance measuring sensor Accuracy 1MM

Operating voltage: 3.0V-5.5V
  • Work instantaneous current 10.6mA / 5.0V
  • Current :1.6-2.7 mA  at 5.0V, typical
  • Operating frequency – 40KHz
  •  Communication frequency -18KB/S
  • Working temperature: -30 C ~ + 85C
  •  KS103: L42mm x W 20mm x H17mm;

Output: digital output, according to the different measuring instructions directly output distance mm or time value to us.

Measuring advantage: the maximum range of 8 meters, the blind area of minimum 1 cm. Accuracy of measurement, on average, 3 mm, up to 1 mm. And quite sensitive. With the other similar ultrasonic module products cannot be achieved by the performance advantage and quality assurance. Measure distance, temperature, light intensity, triad function.
Note:
1, the reason of ultrasonic characteristics of itself, for the surface level off, the object of high hardness test effect is better; For irregular surface, soft objects the test results were limited;
2, within the detection range, the target object and module in the vertical state, the measurement effect is best;
3, this module need waterproof fire roast;
4, pure power can make the measurement effect is best; But this module contains adjustable filtering noise reduction technology, can choose different levels of noise reduction according to the power supply noise size instruction, so that the test is normal;
KS101B/KS103 advantage of distinctive features:
1, USES the innovative features of SLAVE I2C technique, with standard I2C interface with the host communication, do not take up single-chip timer, can also be Shared with other device bus. So a host can take up to 20 KS101B/KS103 modules. Each between the response time of 2-33 ms;
In one of the module to detect work, other modules is automatically entered into dormancy, low power consumption by the test, which USES only 3.0 v voltage (about two dry cell voltage) to supply the 20 KS10 products, still can detect. This is not possessed by other modules.
2, with temperature compensation function, high measurement precision, using the temperature correction range command, the highest accuracy up to 1 mm, close range error is 0.152 mm / 17 cm; Here is 20 cm and 50 cm, according to the measuring accuracy of the diagram below.
Other video shows the metope of 4 meters, measurement accuracy is still close to 1 mm

商品評價

目前沒有評價。

搶先評價 “KS103 高精度超聲波測距模組 支援 I2C 和 TTL串口通訊 1cm-8M 高精度1mm”

相關商品